Fit Guide

Hitch Basics
Class I (light-duty) 2,000 lbs. Maximum 200 lbs. Tongue Weight (TW).
 Receiver hitch uses 1-1/4″ sq. mounts with 1/2″ diameter receiver pin.
Class II (medium-duty). Maximum 350 lbs. TW.
Receiver hitch uses 1-1/4″ sq. mounts with 1/2″ diameter receiver pin.

Class III (heavy-duty) Maximum 500 lbs. TW.
 Receiver hitch uses 2″ square mounts with 5/8″ diameter receiver pin.
Class III (heavy-duty) Maximum 500 lbs. TW.
Receiver hitch uses 2″ square mounts with 5/8″ diameter receiver pin.

Class-II-Receiver-Hitch

Class-II-Receiver-Hitch

Class-III-Receiver-Hitch

Class-III-Receiver-Hitch

 

 

 

 

Wizard Kinetics Bicycle Carriers Hitch Information
Wizard Kinetics is constantly testing the fit of our carrier on different brands and types of vehicles.

Our carrier attaches to a Class III Receiver Hitch. This hitch has a 2” square opening. The other common types of receiver hitches are Class I and II. Both Class I & II have 1.25” square openings. Wizard Kinetics is developing a hitch for 1.25” receivers, so check back soon if you have a Class I or II.

Our carrier will fit most SUV type vehicles and the opening of the tailgate is no problem. Vehicles with tailgates that swing to the side (not up) will have problems opening the tailgate. These vehicles usually have the spare tire attached to the tailgate. If you have a vehicle of this type contact us with the make, year, and model of your vehicle and we will determine if there is an interference problem.

If the center-line of the receiver is less than 12″ above the ground we have carriers with modified support frames that will raise the carrier to the proper height.

Comments are closed.